The linear guide rail shakes during operation, and the temperature is high. This phenomenon usually occurs in the top bar motor of the table, and we can judge whether it is the cause of the slide guide rail through our power off inspection.
The linear guide rail will give an alarm when it is just started, or it will give an alarm after running for a while, and it will give an alarm after running for a while after resetting. Under the normal condition of equipment parameters, this condition indicates that the sliding block or guide rail of the linear guide rail has been worn and needs to be stopped in time for inspection.
When the equipment is stopped or repaired, it is judged that the new slider is going to slide into the guide rail, and the slider should slide left and right. Until the new slider is on the guide rail smoothly and easily without resistance. Install and resume operation. After the sliding block is installed on the linear guide rail, move the position of the sliding block to the position of the sliding block slot on the rotor of the guide rail, and then lay two layers of rags on the guide rail, the thickness of which is about the same as the height of the sliding block. Then gently align the rotor of the motor with the sliding block and slowly fall down until it all falls down!




