Aug 03, 2024 Leave a message

Electric Slide Use Safety Tips

Single/Multi axis robot is also called Electric Actuator (Linear Slider), electric slider (Electric Slider), Linear module (Linear Modular), XY table (XY table), electric cylinder, etc. It is a commonly used execution motion equipment in automation equipment. It is widely used in integrated circuit manufacturing, laser processing, semiconductor, medical equipment and other industries, mainly for workpiece handling, positioning, loading and other functions.

 

In the installation and operation process, depends on the correct use, in order to keep the performance of the electric slide in the best state, pay attention to the following points:


1. Install flatness
According to the accuracy level of the electric slide, the flatness requirement of the installation bottom surface of the general grade should be less than 0.05mm/m, and the flatness of the installation bottom surface of the precision grade should be less than 0.02mm/mm. The bottom surface of the electric slide installation is too large, which is easy to cause the bottom surface of the slide to be forcibly locked, resulting in strong bending and deformation of the bottom surface of the slide, linear guide rail and ball screw.


2. Lock sequence of the screws at the bottom
The fixing screws at the bottom of the electric slide should follow the principle of locking the middle first and then the two ends. If the two ends are locked first, it is easy to cause the arch deformation that cannot be eliminated, which leads to the uneven operation of the linear guide rail, and reduces the parallelism and straightness accuracy of the walking.


3. Concentricity of motor shaft and screw shaft end
Although the coupling can eliminate a certain degree of eccentricity, if the concentricity runout value of the electric slide lead rod shaft end and the motor shaft exceeds the allowable range of the coupling, it will damage the coupling. May cause abnormal coupling or shrapnel fracture.


4. Multi-axis gantry combination mechanical installation height on both sides
When installing the electric slide with the gantry frame, if the guide rail on both sides is uneven, or the slide that needs to be parallel cannot be parallel, the electric slide will be stuck and accelerate the damage.


5. Tightness of the synchronization belt
The tension of the electric slide synchronous belt should be kept moderate. If the belt tension is too tight, the tension of the synchronous wheel and the synchronous belt will be too large, and it is easy to produce abnormal noise. If the tension of the belt is too loose, there will be a gap in the transmission process, reducing the accuracy. In severe cases, skipping teeth can occur.


6. Belt installation
When the synchronous belt is driven by the electric slide, or the motor is mounted on the side of the electric slide, the synchronous wheel should be kept flush; Otherwise, the belt will run off, and then the edge of the belt will rub against the side of the synchronous belt, and the synchronous belt will be damaged and broken in a short time.


7. Mechanical arm (electric slide) cantilever shaft travel
If the cantilever length of the electric slide is too long, the allowable torque of the guide rail will be overloaded. Under different acceleration and deceleration, the closing time will change. The vibration generated during beam collection is eventually absorbed by the electric slide, and long-term vibration will shorten the life of the guide rail.
8. Load
When selecting electric slide, in addition to referring to the transportable load data in the selection manual, the influence of dynamic allowable torque, acceleration and deceleration changes, and cantilever length should be checked, and sufficient safety factor should be left.

 

In general, the precision of the electric slide is relatively high, whether the internal installation or the external installation requires great attention, professional consideration and professional installation. Otherwise, it is easy to damage the electric slide and shorten the life of the slide.

Send Inquiry

whatsapp

Phone

E-mail

Inquiry