As an important part of supporting and guiding motion, linear guide can perform reciprocating linear motion in a given direction. If it depends on its conflict nature, it can be divided into sliding conflict guide, rolling conflict guide, elastic conflict guide, etc. Generally, bad conditions will occur during operation.
In particular, some guide rails will swing to the side when the clearance is relatively large, so that bad noise will be formed between the sliders. Therefore, technicians need to be highly alert to the "fault signal" of linear guide bearings, which can be identified by hearing.
The guide rail and slide block are the key parts of the linear guide rail, and the equipment cannot operate without guide rail. However, during the operation of our equipment, there are many factors that cause the damage of our linear guide rail slide block. At this time, we need to timely check and judge their quality, and do a good job of prevention as early as possible.
