GDZ-125-5.5 Water Cooled Spindle 5.5 kW ER25
video

GDZ-125-5.5 Water Cooled Spindle 5.5 kW ER25

5.5 kW water cooled round spindle in a 125 mm body with ER25 collet up to 16 mm. Three-phase 380 V at 10.5 A, 24000 rpm at 400 Hz.
Send Inquiry
Add To Inquiry
Product Introduction

Overview

The GDZ-125-5.5 is a 5.5 kW water cooled spindle in a 125 mm body with an ER25 collet that takes up to a 16 mm shank. It runs on three-phase 380 V and is the usual step up from a 3.7 kW 220 V unit when a workshop already has 380 V power and production runs are long. The larger body means more mass and a stiffer shaft, so deep cuts in hardwood and stone are steadier than on an 80 or 100 mm spindle.

Specifications

Item Value
Model number GDZ-125-5.5 Φ125×300
Power 5.5 kW
Voltage 380 V
Current 10.5 A
Frequency 1–400 Hz
Speed 1–24 000 rpm
Collet ER25, max clamping 16 mm
Body diameter 125 mm
Body length 300 mm (325 mm overall)
Cooling Water cooling, hose Ø6ר8

What the 125 mm frame changes

Two things. Stiffness - the larger diameter and bearing spacing resist deflection, so a 16 mm cutter at depth does not chatter the way it can on an 80 mm spindle. And airflow - the bigger jacket carries more coolant, which matters when you are cutting continuously rather than in short jobs. The trade-off is weight: check that your Z axis and its brake can hold the spindle plus the bracket.

GDZ-125-5.5 water cooled spindle specifications

Power supply and wiring

This is a 380 V three-phase spindle. Confirm the site has 380 V before ordering, then choose a VFD of 5.5–7.5 kW class with three-phase input. Set the nameplate current (10.5 A) as the motor reference, cap frequency at 400 Hz, and let the spindle idle at low rpm for the first run while you bleed air out of the water jacket.

Applications

Solid wood and hardwood routing, stone and quartz with the stone-cutting variant, plastic and acrylic at high removal rates, and production runs where the spindle works most of the day.

FAQ

Can I run it on 220 V with a transformer? Not practically - 5.5 kW at 220 V draws a current that most single-phase supplies cannot hold. Take the 3.7 kW 220 V model instead.

Does ER25 accept ER20 collets? No, collet series are not interchangeable. ER20 tools need an ER20 spindle.

Is a chiller required? Not for most woodwork; a pump and a 20 litre tank are enough. Use a chiller if ambient temperature is high or the spindle runs continuously for hours.

What coolant should I use? Clean water with a corrosion inhibitor; antifreeze mix if the shop drops below freezing.

Related products

Step down to the GDZ-100-3.7 if the site is 220 V only, compare the STZ 0.8–2.2 kW range for lighter work, and match it with an HS720 inverter.

Hot Tags: 5.5kw water cooled spindle, ER25 spindle, 380V CNC spindle motor, 20000 rpm spindle, 200w spindle motor, 575v vfd, 7 5 hp variable frequency drive, best spindle motor for cnc router, Spindle Collet

Send Inquiry

whatsapp

Phone

E-mail

Inquiry